Oil and Gas separation filter element 1622007901

Product introduction

Atlas oil and gas separation filter 1622007901 adopts the more advanced anti-corrosion and efficient microfiber condensate material as the main filter, air compressor series filter element makes the output air of the compressor more than 3μm solid particles can all be filtered out, and the very small about 0.01-1μm of oil water and gas dissolution through the filter element is condensed into larger oil droplets, Accumulates at the bottom of the filter element, and then siphon back to the lubrication system through the return pipe at the bottom of the concave of the filter element, so that the compressor can discharge more pure, oil-free compressed air.

Technical parameter

Accuracy of technical parameters: 0.1&μm

Filtration efficiency: 99.99%

Initial pressure difference: ≤0.02Mpa

Service life: 3500-5200h

Oil content: 3-6PPm

Working principle

The oil and gas separator adopts the most advanced anticorrosive and efficient microfiber condensed material as the main filtration body. The filter bed of the filter element of the system is composed of the pre-filtration layer, microfiber layer, support layer, filtration layer and gravity settling layer

Matters needing attention

1. In the process of using the oil and gas separator, the normal pressure difference of the newly installed oil and gas separator is between 0.17 and 0.3bar, and it is abnormal if it exceeds 0.3bar.

2. In the process of using oil and gas separator, when the pressure difference is greater than 0.8bar, it is abnormal. At this time, it is necessary to check the air compressor air system, check whether the air filter can filter 5-6um magazines to reach 95% or more, and reach 99.8% of impurities in 7-10um. Otherwise, the oil and gas separator core will have a pressure difference of more than 0.8bar in advance in use.

If the core pressure difference of the oil and gas separator is greater than 1bar during use, replace the core of the oil and gas separator.

common problem

1. When the final pressure difference is reached, the filter element of the oil and gas separator must be replaced. Attention must be paid to the installation or replacement of the filter element to ensure that the conditions are not wrong. If the seal is rotated correctly (with anti-static measures) to discharge the remaining oil from the return oil management, the return pipe must have sufficient length to reach the bottom end cap, etc.

2. When installing and replacing the filter element of screw air compressor, the most important thing is to ensure that the lubricating oil in the separation tank and the dry side of the oil filter element are clean, and the surface of the filter element separation layer is easy to operate, so that the amount of oil carried is increased, the efficiency is reduced, and the dry side of the filter element contains impurities and plugs the return oil pipeline, resulting in the phenomenon of gas with oil.

Product details