Oil and Gas separation filter element 1622051600

Product introduction

Atlas oil and gas separation filter 1622051600 adopts the more advanced anti-corrosion and efficient microfiber condensate material as the main filter, air compressor series filter element makes the compressor output air more than 3μm solid particles can all be filtered out, and the very small about 0.01-1μm of oil water air dissolution through the filter element is condensed into a larger drop of oil, Accumulates at the bottom of the filter element, and then siphon back to the lubrication system through the return pipe at the bottom of the concave of the filter element, so that the compressor can discharge more pure, oil-free compressed air.

Technical parameter

Accuracy of technical parameters: 0.1&μm

Filtration efficiency: 99.99%

Initial pressure difference: ≤0.02Mpa

Service life: 3500-5200h

Oil content: 3-6PPm

Performance characteristics

Atlas oil and gas separation core is a flange hole group positioning installation oil and gas separation core, oil and gas separation element is the key component that determines the quality of compressed air in the air compressor. The compressed air from the air compressor entrails large and small oil droplets. Large oil droplets are easy to separate through the oil and gas separator, while small oil droplets (suspended oil particles) must be filtered through the micron grade glass fiber filter layer of the oil and gas separator.

Matters needing attention

1. In the process of using the oil and gas separator, the normal pressure difference of the newly installed oil and gas separator is between 0.17 and 0.3bar, and it is abnormal if it exceeds 0.3bar.

2. In the process of using oil and gas separator, when the pressure difference is greater than 0.8bar, it is abnormal. At this time, it is necessary to check the air compressor air system, check whether the air filter can filter 5-6um magazines to reach 95% or more, and reach 99.8% of impurities in 7-10um. Otherwise, the oil and gas separator core will have a pressure difference of more than 0.8bar in advance in use.

If the core pressure difference of the oil and gas separator is greater than 1bar during use, replace the core of the oil and gas separator

Product details