Product
6211472350HWS air filter
6211472350HWS air filter
6211472350HWS air filter
6211472350HWS air filter
6211472350HWS air filter
6211472350HWS air filter

6211472350HWS air filter

Atlas 6211472350HWS air filter​ adopts advanced anticorrosive and efficient microfiber condensed material as the main filter

  • Operating temperature ≤80℃

Product introduction

Atlas 6211472350HWS air filter adopts advanced anticorrosive and efficient microfiber condensed material as the main filter, so that the solid particles above 3μm in the output air of the compressor can be all filtered out, and the very small about 0.01-1μm oil water and gas dissolved disintegration through the filter is condensed into larger oil droplets, Accumulates at the bottom of the filter element, and then siphon back to the lubrication system through the return pipe at the bottom of the concave of the filter element, so that the compressor can discharge more pure, oil-free compressed air.

Performance characteristics

1. Atlas oil and gas separation core is a flange hole group positioning installation oil and gas separation core

2. Oil and gas separation element is the key component that determines the compressed air quality of air compressor

3. The compressed air from the air compressor entrails large and small oil droplets. Large oil droplets are easy to separate through the oil and gas separator, while small oil droplets (suspended oil particles) must be filtered through the micron-grade glass fiber filter material layer of the oil and gas separator.

Matters needing attention

1. In the process of using the oil and gas separator, the normal pressure difference of the newly installed oil and gas separator is between 0.17 and 0.3bar, and it is abnormal if it exceeds 0.3bar.

2. In the process of using oil and gas separator, when the pressure difference is greater than 0.8bar, it is abnormal. At this time, it is necessary to check the air compressor air system, check whether the air filter can filter 5-6um magazines to reach 95% or more, and reach 99.8% of impurities in 7-10um. Otherwise, the oil and gas separator core will have a pressure difference of more than 0.8bar in advance in use.

If the core pressure difference of the oil and gas separator is greater than 1bar during use, replace the core of the oil and gas separator.

Product details


Similar ProductsVIEW MORE >

Online message

We will contact you within 24 hours

GET GUIDANCE
Copyright © Aite(Henan) environmental protection equipment Co.

icon_online

icon_email

Contact Us

icon_wehtapp Contact Us