91108-022 recovery oil and gas separator

Product introduction

91108-022 Fu Sheng oil and gas separator mainly refers to the air compressor oil filter element, air compressor air filter element and air compressor oil and gas separation filter element, Aite filter production of air compressor three filter brands are Ingersoll Rand, Fu Sheng, Shouli, Fidelity, Atlas and so on. 91108-022 Fusheng Oil and gas separator is the domestic replacement product of Fusheng screw air compressor filter element produced by us. It has remarkable effect on oil and gas separation, and has the advantages of anti-corrosion and anti-aging. It can be used interchangably with the original products.

Technical parameter

Model number: 91108-022

Filtration accuracy :0.1micro; m

Filtration efficiency is 99.999%

The oil content of compressed air can reach less than 3ppm

The service life can reach about 3500~5200h

Initial pressure difference: 0.02MPa

Filter material selected HV(Binzer) and Lydall glass fiber production company

Performance characteristics

The compressed air from the air compressor entrails large and small oil droplets. Large oil droplets are easily separated through the oil and gas separator, while small oil droplets (suspended oil particles) must be filtered through the micron glass fiber filter material layer of the oil and gas separator. 91108-022 Adopts the most advanced anticorrosive and efficient microfiber condensed material as the main filter, so that the solid particles above 3μm in the output air of the compressor can be all filtered out, and the very small about 0.01-1μm of oil water and air dissolves through the filter element is condensed into a larger oil drop, accumulated at the bottom of the filter element, Then siphon back to the lubrication system through the return pipe at the bottom of the hollow of the filter element so that the compressor can discharge more pure, oil-free compressed air.

Working principle

1. The lubricating oil surface in the oil and gas separator barrel should be controlled in the specified position, usually 1/2~2/3 of the oil speculum.

2. The secondary return tubing and check valve shall be kept unobstructed and in the specified position.

3. Adjust the exhaust pressure to the specified value.

4. The operating temperature and pressure of the compressor are normal.

Product details