HYDAC filter_Aite(Henan) environmental protection equipment Co.

Product introduction

The filter is composed of two parts, the upper filter head material is cast iron QT450, the lower filter cylinder is carbon steel.

The filter is available without a by-pass device and with a by-pass device, the user should declare when ordering.

Technical parameter

Glass fiber filter element filtration accuracy: 3, 5, 10, 20μm

Metal mesh material filter element filtration accuracy: 25, 50, 100, 200μm (metal mesh filter element can be cleaned)

Flow direction: The entrance and exit are on the opposite side of the same height.

Connection mode of oil inlet and outlet: 30 to 280 thread link, 330 to 1300 thread and SAE flange link.

Fixing mode: Fixed through the four screw holes at the upper end of the filter.

Operating temperature: -10℃ -+ 100℃

Applicable medium: mineral oil, lubricating oil

Performance characteristics

The high pressure filter element used in the filter is divided into BH (high pressure difference) and BN (low pressure difference) two kinds.

The filter is equipped with a pollution transmitter (visual or electrical signal indication), for the filter element is blocked by pollutants in the filter signal indication, so that maintenance personnel to replace the filter element.

The filter element is made of glass fiber material folded, which has the advantages of high filtration accuracy, large oil flow, small original pressure loss and large contaminant capacity.

Working principle

The high pressure filter element used in the filter is divided into BH (high pressure difference) and BN (low pressure difference) two kinds.

The filter element is made of glass fiber material folded, which has the advantages of high filtration accuracy, large oil flow, small original pressure loss and large contaminant capacity.