The anti-leakage gas drain is characterized by large drainage flow, which can reach 20 tons/hour; high sensitivity, instantaneous overpressure value of up to 0.015MPa; double protection function, which greatly prolongs the service life of the equipment.
The structure of the anti-leakage gas drain is mainly composed of a gas drain device and an anti-leakage gas device. Mainly used for the discharge of condensed water in overhead gas pipelines. This product adopts a fully enclosed thermal insulation structure caused by pressure fluctuations in the gas pipe network or other reasons, and adopts electric heat tracing for thermal insulation, which can save a lot of electric energy, and can also ensure the normal and continuous operation of the drainage device without freezing.
The main function of the anti-leakage gas drainer: after the sewage in the gas pipeline passes through the drainer produced by our company, the impurities are filtered and precipitated, which improves the water quality and does not pollute the environment.
The inspection step of the anti-leakage gas drain is that it can send out classified alarm information in time, and it can be monitored and monitored centrally, and it will not be affected by the voltage drop caused by the long transmission distance. The condensed water in the anti-leakage gas drain is prone to freezing, which makes the drain ineffective. In severe cases, the drain is frozen and cracked, causing gas leakage. In winter, the descending pipe and cylinder body of the drainer need to be insulated. When there is steam on site, use a steam pipe to trace heat along the descending pipe of the anti-leakage gas drain, and use a rubber pipe to connect the steam tracing of the descending pipe and the exhaust port of the final chamber to keep the condensed water in the anti-leakage gas drain insulated. If there is no steam condition on site, electric heat tracing device can be used. During the heating process, the temperature can be automatically adjusted within 10-30°C for temperature control. When the water temperature is lower than the set value, the electric heating system will work automatically. When the water temperature is higher than the set value, the automatic working system of the electric heating system will automatically stop working and enter the state of automatic heat preservation. normal operation. The outer side of the cylinder adopts thermal insulation layer, the thermal insulation material is aluminum silicate fiber (thickness 50mm), and the color plate is used as the shell of the leak-proof gas drain, which is beautiful and strong.
