The compressed air from the air compressor entrails large and small oil droplets. Large oil droplets are easy to separate through the oil and gas separator, and small oil droplets (suspended oil particles) must be filtered through the micron grade glass fiber filter layer of the oil and gas separator.
The compressed air from the air compressor entrails large and small oil droplets. Large oil droplets are easy to separate through the oil and gas separator, and small oil droplets (suspended oil particles) must be filtered through the micron grade glass fiber filter layer of the oil and gas separator. Ingersoll Rand 38008587 oil core adopts advanced anticorrosive and efficient microfiber condensate material as the main filter, so that the output air of the compressor more than 3μm solid particles can all be filtered out, and the very small about 0.01-1μm oil water air dissolution through the filter is condensed into a larger oil droplets, accumulated at the bottom of the filter, Then siphon back to the lubrication system through the return pipe at the bottom of the hollow of the filter element so that the compressor can discharge more pure, oil-free compressed air.
1. Filtration accuracy :0.1micro; m
2. Filtration efficiency is 99.999%
3. Oil content of compressed air can be controlled below 3~6ppm
4. The service life can reach about 3500~5200h
5. Initial pressure difference: ≦0.02MPa
6. The filter material is made of glass fiber from American HV(Binzer) and American Lydall
Filter element mdash; Crack resistance is verified according to ISO 2941
Filter element mdash; Structural integrity according to ISO 2942
Filter element mdash; Material and liquid communication compatibility verification according to ISO 2943
Filter element mdash; End load test method according to ISO3723
Filter element mdash; The filter element fatigue characteristics were determined according to ISO3724
Filter element mdash; Pressure differential flow characteristics were determined according to ISO3968
Filter element mdash; The multiple pass method for determining filtration characteristics is ISO4572
1. The lubricating oil surface in the oil and gas separator barrel should be controlled in the specified position, usually 1/2~2/3 of the oil speculum.
2. The secondary return tubing and check valve shall be kept unobstructed and in the specified position.
3. Adjust the exhaust pressure to the specified value.
4. The operating temperature and pressure of the compressor are normal.
54509435 air compressor oil gas separation filter element
Similar ProductsVIEW MORE >