Product
ZU-H inverted high pressure filter
ZU-H inverted high pressure filter
ZU-H inverted high pressure filter
ZU-H inverted high pressure filter
ZU-H inverted high pressure filter
ZU-H inverted high pressure filter

ZU-H inverted high pressure filter

The filter is installed in the hydraulic system pressure pipe, to filter the hydraulic oil mixed with mechanical impurities and chemical changes in the hydraulic oil itself produced by gum, leachant, carbon slag, so as to prevent the valve core stuck, orifice gap and damping hole blockage and hydraulic components too fast wear and other failures.

  • Filtration accuracy of 10~30 μm

Product introduction

The filter is installed in the hydraulic system pressure pipe, to filter the hydraulic oil mixed with mechanical impurities and chemical changes in the hydraulic oil itself produced by gum, leachant, carbon slag, so as to prevent the valve core stuck, orifice gap and damping hole blockage and hydraulic components too fast wear and other failures. The filter filter effect is good, high precision, but it is difficult to clean after plugging, and the filter element must be replaced. The filter is provided with a pressure difference signaling device, when the filter element is polluted and blocked until the oil inlet and outlet pressure difference is 0.35MPa, the switch signal is sent, and the filter element is replaced at this time, so as to achieve the purpose of protecting the system safety. The filter element is made of new chemical fiber filter material, which has the advantages of high filtration accuracy, large oil passing capacity, small original pressure loss and large contaminant carrying capacity. Its filtration accuracy is calibrated by absolute filtration accuracy, filtering ratio 93, 5, 10, 20gt; 100, filtration efficiency ngt; 9Q %.

Performance characteristics

ZU-H series filters are installed in the oil return filter of the hydraulic system to remove metal powder and rubber impurities worn by various components in the oil, so that the oil flowing back to the tank to keep clean, conducive to the circulation of the oil in the system.

The filter is divided into chemical fiber type, paper type, mesh type and line gap type four. Chemical fiber filter is better than paper filter, high precision, chemical fiber filter and paper filter is more difficult to clean after plugging, so the filter must be replaced.

The filter is equipped with a differential pressure signaling device. When the filter seal is polluted and blocked, the differential pressure of the inlet and outlet reaches 0.35MPA, the switch signal will be sent. At this time, the filter element should be cleaned and replaced.

The filter element is made of stainless steel wire, or copper wire winding material, which has the advantages of high filtration accuracy, large oil passing capacity, small initial pressure loss, large contaminant amount, etc., and equipped with differential pressure transmitter and bypass valve.

Flow rate: (10L-1000L)/min Pressure: 1.6MPA Filtration accuracy: (1, 3, 5, 10, 20, 30, 40, 100) mu; micron

Working principle

ZU-H series filters are installed in the oil return filter of the hydraulic system to remove metal powder and rubber impurities worn by various components in the oil, so that the oil flowing back to the tank to keep clean, conducive to the circulation of the oil in the system.

Product details

管路过滤器落地页英文版9

ZU-H inverted high pressure filter

email

aiteepcom@163.com

whatsapp

+ 0086-13015535452

Similar ProductsVIEW MORE >

  • ZU-H line filter

    ZU-H line filter

  • ZU-H160*20P high pressure filter

    ZU-H160*20P high pressure filter

  • Online message

    We will contact you within 24 hours

    GET GUIDANCE
    Copyright © Aite(Henan) environmental protection equipment Co.

    icon_online

    icon_email

    Contact Us

    icon_wehtapp Contact Us