Why water leakage occurs during the use of brush automatic cleaning filter?
Brush type automatic cleaning filter has automatic cleaning, blowdown, filtration and other functions, is used in many fields. However, in the long time of use, there will inevitably be some problems, which will affect the normal and operation of the whole system. In these failures, water leakage should be one of the common problems. The following Xiaobian for everyone to carry out a simple analysis, hope to help you.
Brush type automatic cleaning filter water leakage position is mostly in the filter shaft part, the quality of equipment parts and use time are the cause of water leakage. When the sealing ring material of the drive shaft is not qualified and is not manufactured in accordance with the requirements, it will lead to the occurrence of water leakage. At this time, the sealing ring needs to be replaced.
Secondly, under the use of a long time, the sealing ring will appear wear condition, which causes the transmission shaft and the filter between the sealing worse, the gap becomes larger, the phenomenon of water leakage, the same sealing ring replacement and detection, to ensure the good condition of the equipment.
In addition to the transmission shaft, the cylinder, welding, etc., will also become the brush type automatic cleaning filter water leakage. Cracks or deformation of the cylinder, welding parts are not in place, rough and so on will cause the occurrence of water leakage.
Therefore, the water leakage problem should be found in time to solve the problem in time. It is very important to be familiar with the basic structure of brush automatic cleaning filter, select good products and maintain them in time to ensure the normal operation of water system.
