PLF Pressure Line filter The hydraulic filter can be installed on pressure lines of different pressure levels to further remove or block impurities caused by external wear during component operation and the chemical action of the medium itself.
PLF Pressure Line filter The hydraulic filter can be installed on pressure lines of different pressure levels to further remove or block impurities caused by external wear during component operation and the chemical action of the medium itself. Especially suitable for automatic control system and servo system. It can prevent high-precision control components and executive components from premature wear or sticking due to pollution, thus reducing failures and extending the service life of components.
The filter adopts imported glass fiber filter material, which has the advantages of high filtration precision, strong oil passing ability, small original pressure loss and large amount of pollution. Filtration accuracy was calibrated by absolute filtration accuracy, and its filtration ratio was beta. 3, 5, 10, 20ge; 200 filtration efficiency nge; 99.5%. Comply with ISO standards.
Nominal flow: 30-660L/min
Nominal pressure: 6.3MPA 16MPA 32MPA
Filtration accuracy: 10-20μm
Nominal diameter: 30-50mm
Connection mode: threaded flange
1: Compared with the same flow, compact structure and small volume.
2: Wide range of pressure.
3: Easy to change the filter element, users can open the top cover according to the installation control, replace the filter element, also can unscrew the shell (first put oil) from the following filter element.
4: Easy to install and fix: if the user is difficult to install according to the standard flow direction, the four screws on the cover can be removed and the cover can be rotated 180 degrees. This changes the flow direction of the medium.
5: The filter is provided with a by-pass valve and differential pressure signaling device, double protection function, when the filter element pollution and blockage until the inlet and outlet pressure difference value is set for the signaling device, the signaling device sends a message, at this time, the filter element must be replaced.
Installed in different pressure levels of the pressure pipe, to further remove or block due to external wear components, as well as the chemical action of the medium itself caused by impurities. Especially suitable for automatic control system and servo system. It can prevent high-precision control components and executive components from premature wear or sticking due to pollution, thus reducing failures and extending the service life of components.
PLF series pressure line filter _PLF-C60×10P
Similar ProductsVIEW MORE >
Export01@aiteeps.com
+0086-13015535452
