Fully automatic brush filter

Structural principle

The internal structure of Fully automatic brush filter is composed of stainless steel wire brush and stainless steel screen and transmission parts, by the transmission motor and electric valve to complete automatic cleaning and blowdown, operation mode for automatic operation (manual operation), with pressure difference and timing automatic blowdown dual functions.

When the water flows through the filter, the mechanical impurities in the water are intercepted by the filter screen, when the impurities accumulated on the surface of the filter screen increase and the pressure difference reaches the set pressure difference, the pressure difference switch sends a signal, at the same time, the control box is issued instructions, the driving motor starts, the drain valve opens, the impurities deposited in the filter screen are rotated by the brush and discharged from the sewage outlet, The whole process of scrubbing blowdown does not require personnel operation or shutdown. At the same time, the equipment is also equipped with periodic cleaning blowdown and manual cleaning blowdown functions to ensure safe and reliable discharge under any circumstances.

Technical parameter

Filtration accuracy：50-1000μm (customizable)

Engineering pressure：0.6MPa, 1.0MPa, 1.6MPa, 2.5MPa

Motor power：0.18KW, 0.37KW, 0.55KW, 0.75KW, 1.5KW

Structural form：L type (Y type, F type can be customized)

Applicable temperature: -10-90℃

Backwash time: 60-120s (adjustable)

Filter element material：304/316 (Punching, weaving, sintering, wedge)

Power supply：AC308V/50Hz

Connection mode：Flange connection (optional)

Matters needing attention

The equipment has been debugged before leaving the factory, and users can run it directly when using it. When the operating parameters of the equipment cannot meet the requirements of the user, the user can adjust the parameters according to the actual working conditions, and choose the manual control or automatic control mode to work accordingly.

For the first run, follow these steps:

Check whether the filter is in normal working condition:

Check whether the connection of the filter is firm.

Check the electric cabinet part of the filter should be dry.

When the power supply is switched on, the green power indicator lights up, indicating that the electronic control part of the filter is in normal working state, and the equipment can be put into trial operation.

Note: Keep your hands dry when you plug in the power supply. At the same time, keep the electric control unit dry during the working process of the filter. No water can enter the electric control unit.

Product characteristics