Horizontal shallow sand river water filter

Product Introduction

Horizontal shallow sand river water filter adopts modular design, which can be flexibly combined according to different flow rate and land area. The system can use time, pressure difference and other ways of automatic backwash, automatic operation. The filtration units in the system are backwashed in turn, and the effluent is not interrupted during backwashing. Horizontal shallow sand filter filtration system is lightweight and requires no special foundation treatment. Small footprint, according to the actual situation can be flexibly arranged, easy to install

Principle of Operation

When the system is in the filtering state, the pressurized water flows into the water distribution system from the filter tank inlet and uniformly reaches the filter material layer. When the water passes through the filter material layer, the suspended matter is intercepted by the filter material. Water flows through the bottom with a water collector, is evenly collected, and out of the filter. The gap on the water collector can prevent the loss of filter material. When the system is in the automatic backwash state, the backwash cycle is controlled by increasing pressure differences and set times. With the continuous accumulation of impurities in the filter material layer, the pressure loss is increasing. When the pressure difference increases to a - set value (or reaches a - set time value), the system automatically switches to the backwash state. Pressurized water (water collection device) into the filter material layer, the brush, so that the intercepted pollutants fall off and out of the filtration system. After the backwash lasts for at least 2 minutes, the valve automatically switches the system to the filtered state.

Back wash condition

When the system running time or operating pressure difference reaches the set value, the system enters the backwash state, at this time the controller sends the backwash signal to the solenoid valve, the solenoid valve through the compressed air signal, the gas into the pneumatic device, the connecting rod structure controls the four ball valves at the same time, the system enters the unwashed state, pressurized water through the ball valve S3 into the collection device. Ball valve S4 closed, pressurized water through the collector into the filter material layer, wash it, so that the intercepted pollutants fall off, through the valve closed, into the discharge pipe, backwash for 2 minutes, the valve automatically jump to the filter state.

Product Details