Gas line drainer

Product Introduction

Gas line drainer is a closed drainer. If there is water in the gas pipeline, the water will be drained. If there is no water, the water will be closed. It can quickly, strictly and accurately cut off the gas to leak, and even when there is no water in the overpressure protection, it can still cut off the overpressure gas, automatic identification, without any power; The drainage is smooth, can prevent the sludge blockage, the cleaning cycle is extended by more than two times (generally 1-2 years), and can mechanically clean the dead Angle of slag accumulation; In particular, the over-leakage prevention device can not only block all kinds of over-pressure gas, but also prevent moisture volatilization.

Precautions for installation and use

Gas pipeline drainer to be installed on the flat ground foundation, to vertical installation, not tilt, to ensure that the drainer work reliably.

The onsite gas pipe should be connected with the gas entry pipe of the gas drainer, and the flange should be connected with a gasket to ensure tight sealing and no gas leakage. The condensate drainpipe of the drainer must be connected to the nearby sewer. Do not directly discharge the condensate water to the base of the device.

There should be guardrail and warning board around the drainer to prevent collision leakage and other accidents. Before use, add water to the gas drainer! When adding water, it is necessary to open the air discharge valve of the leak-proof device on the top of the gas drainer, and then add water to the drainer by using the water inlet of the room of the condensate water inlet on the drainer. When the lower condensate drainpipe drains outwards, the drainer is finished adding water. After adding water, the drain valve should be closed to prevent gas leakage.

Product Details